Why is my wii not reading games

Develop and improve products. List of Partners vendors. By Charles Herold Charles Herold. A former Lifewire Writer, Charles Herold has been reviewing and writing about Nintendo video games, consoles, and peripherals for two decades. Reviewed by Ryan Perian. Tweet Share Email. Don't exert more force than necessary; it's a flimsy disc. Was this page helpful? Thanks for letting us know! Email Address Sign up There was an error. Please try again. You're in! Thanks for signing up.

There was an error. Tell us why! If the cables and the drive are not the problem that cause the DVD drive not to turn on, then it may be a bad motherboard. It is difficult to test this without obtaining a new motherboard or testing your DVD drive on a known working console. If the drive still works on another board, then you will have to replace the motherboard. If the disc is spinning in the DVD drive, but the console can't read it, then there may be a bad connection with the data cable.

First, remove the DVD drive to check the connection there. If it's fine, you'll have to access the connection on the motherboard to make sure it is also secure.

At this point, if the connections are fine, you might also want to try a different data cable, though it is not likely that the cable is the problem unless there is obvious damage to it.

If the Wii takes discs, but cannot read them, then there is likely a problem with the laser lens in the DVD drive. Though it is possible to just replace the laser, it is easier and more reliable to replace the DVD drive. If your Wii is very warm to the touch, this can cause disk read errors. If this is the case, then completely shut down the Wii red LED and allow it to cool down, and then try again.

It is possible that your Wii remote has "lost" its sync. You can clear all previous synced Wii remotes with your console and reconnect the ones you are using. Power off the console and unplug the power cord for a few seconds. Plug the power cord back in and turn the Wii back on. At the "Health and Safety" screen, open the small door on the faceplate of the console. Hold the red sync button for at least 15 seconds. All previous syncs have been removed from your console at this point.

This process does not need to be repeated to re-sync each remote. Take the first Wii remote you wish to sync and remove the door to the battery compartment. Press and release the red sync button near the batteries. Quickly press and release the red sync button on the console. The lights on the remote will flash and then illuminate the light that corresponds to that remote's position 1, 2, 3, or 4.

Repeat this process for each Wii remote in any desired order. As the console ages, the fan may become clogged or eventually fail, causing the console to overheat, which could lead to much more serious damage to the device. Remove the fan to clean it or replace it with a new one. If the noise only happens when there is a disc inserted in the drive, the drive might be failing.

Unable to read the disc Support Wii. Ensure that you are properly loading a Game Disc. If your console is placed vertically, the disc label will face to the right. Share on:. Search Support section Search. Cancel Continue. Dear visitor, Thank you for visiting the Nintendo website! Naturally, any information provided by you in this survey will be treated in confidence.

Visit us on Twitch: NintendoUK. If it refuses to play games via this method, you may have a serious issue on your hand data corruption. From the command line, just run the md5sum command pretty much standard for all Linux distros on each ISO and compare the generated hash a series of numbers and characters with those of verified working dumps from sites like GameTDB or Redump. If your hashes don't match up with theirs, then you should redump your games until they do match.

Website Find. What I mean by "Not Recognizing" is, Yes it reports that it can find no iso's. The path to their location is fine. I have even tried re-establishing the path but doing the search, when I get to the folder containing my iso's they are all "greyed" out meaning they are unusable or unrecognized.

ExtremeDude2 Gotta post fast. Check out my videos dead. In Dolphin's case, it doesn't make a difference if your ISOs are hidden or not, tried it myself just now.